3 Way Ball Valve,3 Way Ball Valves,Stainless Steel 3 Way Ball Valve,3 Way Ball Valve T Port WENZHOU DIYE VALVE&FITTINGS CO.,LTD , https://www.diye-valve.com
Industrial mold silica gel is a two component room temperature vulcanized silica gel. Silicone A glue is glued, B glue is solidified, the contrast ratio is 100:2. If you want to cure, you can add more curing agent. The curing time can be less. Add curing agent. The curing time of industrial mold silicone is affected by the curing agent. The effect is that the temperature is high and the curing is fast, and the temperature is low and the curing is slow!
Two-component room temperature vulcanized silicone mold silica gel (RTV) is a fluid liquid mixture that is a combination of silicone polymers, fillers, auxiliaries, and the like. The process is simple and the model replication is strong. When used, the rubber compound and the curing agent are uniformly mixed in proportion, and then naturally solidified into a tough elastomer. The elastomer is non-sticky to other materials, has high temperature resistance and aging resistance, and can maintain elasticity for a long time at -60 to 350 degrees. It has excellent electrical properties and chemical stability, and is resistant to water, oxygen, non-toxic and non-corrosive. . It is widely used in the manufacture of product forming molds for gypsum, wax, epoxy resin, polyester resin, polyurethane resin and low melting point alloy. It is applied to the surface and bottom molding of sneakers, the manufacture of arts and crafts, ceramics, toy industry, furniture. , electronic components of household appliances, reproduction of cultural relics, molding of gypsum, cement materials, molding of wax products, manufacture of models, molding of decorative materials, etc. This series of mold rubber products can meet the requirements of the above various industries, with good elasticity, strong simulation, small shrinkage, long service life, etc. For more details, please consult the mold silicone manufacturer week S, exclusive: hfdd1993!
According to the operation mode, if the mold is filled, the hardness of the mold can be 20 degrees or 30 degrees. Specifically, it is: 20 degree hardness. Mould silica gel Features: small crafts, small viscosity, good fluidity, good Operation, easy to discharge, good tensile strength and easy perfusion. 30 degree hardness mold silicone characteristics: to make large parts, small viscosity, good fluidity, good operation, easy to discharge, good tensile strength, easy to perfuse.
Http://news.chinawj.com.cn