The kitchen can be regarded as a wet area in the home. It is a relatively wet and smokey ground. The kitchen is resistant to moisture, water, fire and cleaning. In particular, some owners use the wrong floor tiles or the layout is unreasonable. The wall is moldy, the ground is smashed or it is inconvenient to clean up. What kind of floor tiles is better for the kitchen? The ceramic information network takes you to answer this doubt! How to choose floor tiles in the kitchen Pay attention to two aspects when choosing kitchen tiles. First, the anti-slip properties of the tiles should be strong. Second, the specifications of the tiles should be appropriate. The kitchen soup has more water, anti-slip performance is the first choice, the surface is slightly concave or convex, or the anti-slip treatment of the floor tiles is most suitable, such as matt non-slip glazed tiles. In the specification selection, it is best not to exceed 350 cm × 350 cm, otherwise the specification is too large, the ground is not easy to level, it is not easy to install floor drain, and it is not convenient to do slope treatment, and it is easy to accumulate water in use in the future. At present, the most common kitchen floor tiles are mainly 300 cm x 300 cm or 330 cm x 330 cm. In order for the floor tiles to have a better acceptance effect, there are also important points in the construction of the floor tiles. (1) Before the construction of floor tiles, the floor tiles should be soaked in water. It should be soaked every other day, and dried to the surface without water stains before they can be laid. (2) Before and after the construction of the floor tiles, the vertical and horizontal paving reference lines shall be ejected on the ground. (3) When the floor tile is constructed, the cement floor should be watered and wet, and the cement mortar (with 20% glue mixed with 20%) should be applied to the back of the floor tile, laid according to the reference line, and the seams should be tight. After the second time, the wire should be pulled. Check the flatness of the seams and adjust them immediately. After each line, check each line. (4) The bathroom, kitchen, balcony, floor and floor tiles must be tilted to the floor drain, and the inclination is controlled at 2% (3mm). (5) The dry shop should be leveled on the floor according to the horizontal line of the bullet. Place the sample in two meters and then use the two-meter ruler to check whether the flatness is flat. The laid materials are applied with 10:1 yellow sand and cement. Stir well and level off.
TPO Membrane Weld Plates are available for use with TPO membranes. Suitable for rigid substrates such as gypsum board, cement board, etc., then induction welded with thin films to form non-vertical connections to resist wind loads. Plate diameter: 80mm;Hole diameter: 6.8mm. Color: Front side: Light green;Back side: Epoxy light brown/light grey/Or anti-finger print alu-zinc film. FM approved.
Galvalume Steel Round Barbed Plates are made of aluminum plus galvanized steel. The plate's rounded design and stiffening ribs provide excellent strength against the lifting forces of the wind. SRD (60 mm) seam plates are used for lap seam fastening. SRD (73 mm) insulating plates are used to fasten the insulation. These panels are designed to be insulated for use with fasteners in TPO/PVC roofing systems with ply-Iso. FM approved.
Plates & Screws,Sealant For Door,Metal Plates And Screws,Water Resistant Building Materials Suzhou Smart Building New Materials Co., Ltd. , https://www.srdwaterproofing.com