Many of the furniture in the house was beautiful when it was just bought, but as time went by, it would fade the original color and begin to crack yellow. It was uncomfortable for people to see, and it was still unsightly. It was unsightly, it was lost, and it was really Reluctant, so, do not tangled, or to the home improvement beauty bar! First, cleaning and maintenance of rattan utensils Rattan or bamboo products will have fouling and discoloration after being used for a long time, and can be scrubbed with salt water, which can both decontaminate and make it flexible and resilient. Wipe it with a wet towel to keep it clean. Second, fire board coffee table cleaning On the tea table with a fire board, it will leave behind unsightly patches. At this time, you can sprinkle some water on the table, use the foil in the cigarette box to wipe it, and then scrub it with water to wash away the tea stains. Third, furniture paint hot mark cleaning Hot cup trays, etc., are placed directly on the furniture finish, leaving a circle of hot marks. Generally just use kerosene, alcohol, toilet water or strong tea to wipe the wet cloth, or use iodine on the hot mark gently rubbed or coated with a layer of Vaseline oil; every two days and then wipe the hot mark can be wiped eliminate. Fourth, repair the surface of furniture paint marks Burns such as pyrotechnics, soot, or unlit matches sometimes leave scars on the furniture finish. If it is only a paint burn, you can wipe the traces with a thin layer of hard cloth on the toothpick. Then apply a layer of wax and remove the scar. Fifth, adhesive residue on furniture After the trademark on the furniture is wiped off, it will leave adhesive residue, which is sticky and dirty. It can be wiped off with a rough eraser. The effect is good. The chewing gum on the floor can also be erased with an eraser. Sixth, white table dirty mark clean The white desk and white chair in your home are easy to get dirty. You can't wipe off the dirty marks with a rag. Try to use toothpaste to squeeze on a clean rag. Just wipe it lightly and the stains on the furniture will be removed. Do not use too much force, do not hurt the paint. Seventh, furniture paint scratches and maintenance If the furniture paint surface is scratched and the wood is not touched, it can be applied on the surface of the furniture with a crayon or paint that matches the color of the furniture, covering the exposed background color, and then thinly applying a layer of transparent nail polish. Eighth, the furniture floor cracks recover When there is a crack in the wooden furniture or the floor, the old newspaper can be cut into pieces, and the appropriate amount of alum can be added, and the appropriate amount of alum can be used to boil it into a paste with clear water or rice soup and then embedded in the crack with a knife and smoothed. After drying, the old newspaper will be very firm and then coated. With the same color of paint, the wood can be restored to its original appearance. Ninth, moisture treatment of furniture backboard If the back of the furniture is deformed by moisture, it should be replaced. The furniture must be flat on the four feet, otherwise it will be deformed due to uneven force. Push-pull large closet doors should not be easily installed mirrors, the mirror too heavy will make the door Falling pressure change orbit. Tenth, electroplating switch surface protection If the electroplating switch of an electric appliance is often touched, it will lose its luster and be eroded by sweat. It can often apply petroleum jelly to prevent salt from eroding. Eleventh, maintenance of leather furniture Normally, waxing of leather and wooden furniture should be done regularly, and Bailey beads and other products can be used. Only regular maintenance can be used frequently. Tips: More practical decoration knowledge, real scene with the shoot, please pay attention to the palm of this site (micro signal: mall_jia). Home knowledge Steel poles are commonly used to carry several
types of electric power lines, distribution lines and lighting system. Distribution lines carry power from
local substations to customers. They generally carry voltages from 4.6 to 33kV
for distances up to 30 miles, and include transformers to step the voltage down
from the primary voltage to the lower secondary voltage used by the customer. A
service drop carries this lower
voltage to the customer's premises. Telecommunication Mast, Telecommunication Antenna Mast,Telescopic Telecommunication Mast,Signal Telecommunication Mast Yixing Steel Pole International Trading Co., Ltd , https://www.yx-steelpole.com
