Knife Gate Valve,Knife Gate,Knife Edge Gate Valve,Knife Edge Valve Haogong Valve Co Ltd , https://www.haogongvalve.com
Maintenance
1. Power supply and gas source requirements 1 The power supply must have a ground wire and must be sufficiently grounded. The transformer must be well grounded. Before each use, check that the ground wire knob is tight. 2 The air source used must be effectively filtered. Sometimes secondary filtration devices are needed. The filter should be cleaned in time. Otherwise: water, oil, and dust/dust particles enter the ion generation chamber and adhere to the inner wall of the plastic part. Accumulated to a certain extent, ion needle will be on fire. As a result, the honeycomb part gradually formed a honeycomb-shaped coke damage, and the amount of ion removal gradually decreased; in particular, there was a safety hazard.
2, in addition to the electrostatic effect adjustment 1 In addition to electrostatic effects in addition to static electricity and pressure is inversely proportional to time. The pressure should be 0.3Mpa-0.7Mpa. 2 The distance and angle between the tip of the gun, the nozzle of the wind and the electrostatic field all affect the effect of static electricity. Attention should be paid to debugging until satisfactory.
3, routine maintenance 1 air gun / wind mouth easily broken. When the air gun is used, pay attention to the anti-collision, and pay attention to drop protection after use. Even if the tuyere is fixed, care must be taken to prevent the object from colliding. 2 air gun pressure control valve moderate, moderate point into the universal anti-rust lubricant. 3 When cleaning the ion air gun ion needle and ion needle chamber, use anhydrous alcohol to avoid using water. When cleaning, turn off the power first, then use a camera to unscrew the small plastic cover (also called the air accelerator) in front of the ion air gun head. Use a cotton swab to clean the ion needle and the ion needle chamber with the alcohol. Stains and dirt are clean. 4 The air supply to the ion air gun is best added with a foot switch, or it can be regulated by the electromagnetic valve and mechanical action, which can improve the use effect and prolong the service life.
Precautions
1, the installation instructions must look at the product specification.
2. The socket that connects the high voltage power supply must be reliably grounded.
3, inflammable and explosive environment is not operational ion air gun.
4. Do not repair without authorization.
5, use ion air gun to take care.
Static Eliminator maintenance methods and precautions
The static eliminator is a device or product used to eliminate static electricity in production and life. The static eliminator is a high-voltage power generator that generates a certain value of high voltage and is applied to the discharge needle. Positive and negative static electricity are neutralized, and negative ions and positive static electricity are neutralized. In order to eliminate static electricity and prevent static electricity. It is mainly used in industrial production and belongs to the electronic product line.