Electronic lock installation video step instructions, at the request of the majority of users, this site has been the electronic control lock installation methods published articles published in the purchase guide column, but there are still many people can not fully understand the steps. Therefore, Smart Lock China Network Xiaobian has compiled a number of electronically controlled lock installation videos shared by users. Through video, detailed installation procedures and tutorials for electronically controlled door locks can be introduced, making installation and wiring of electronically controlled locks easier. In most cases, electronic control lock installation must use some accessories. The user should clearly describe the specific door condition and installation requirements when selecting the electronic control lock. The following describes in detail the accessories that may be used for the installation of several electric control locks. The lower door clamp that is matched with the electric lock: When the glass door has no frame, the lower door clamp must be used. The lower door clip is generally made of aluminum alloy material and is directly clamped on the door glass. The upper and lower door clamps that are matched with the electric control lock: When the glass door body is surrounded by glass without borders, the upper and lower door clamps must be selected. Because the upper door clip requires the electronically controlled lock body to be wrapped and fixed on the glass, the upper door clamp is required to have a very good quality and a large volume, and stainless steel materials are generally used. At the same time, the lower door clamp must be matched with the upper door clamp, which is different from the lower door clamp used alone. Upper and lower door clips are more expensive. L-brackets for magnetic locks: When the iron door is open, it is often necessary to use an L-bracket. Most of the brackets are made of aluminum alloy. U-brackets for magnetic locks: U-brackets must be used when the glass door has no borders. The brackets are mostly made of aluminum alloy. The anode lock body that is matched with the cathode lock: This lock body is generally a mechanical anti-theft lock, and the lock tongue requirement cannot be a square tongue. Interested users, you can also view this site before the installation of electrical control lock schematic describes the article. Spring Spring,Large Spring Spring,Customization Of Spring Springs,Customized Processing Of Spring Springs Dongguan Jiufukai Hardware Products Co., Ltd , https://www.jfkspring.com