Proper installation, use and maintenance of the reducer is an important part of ensuring the normal operation of mechanical equipment. Therefore, when you install the gear unit, be sure to carefully assemble and use it in strict accordance with the following installation and use. The first step is to confirm whether the motor and the reducer are intact before installation, and strictly check whether the dimensions of the parts connected to the reducer are matched. Here are the dimensions of the positioning boss of the motor, the input shaft and the reducer groove. tolerance. The second step is to unscrew the screw on the dust-proof hole on the outer side of the reducer flange, adjust the clamp ring so that the side hole is aligned with the dust-proof hole, and insert the inner hexagon to tighten. After that, remove the motor shaft key. The third step is to naturally connect the motor to the reducer. When connecting, it must be ensured that the output shaft of the reducer is concentric with the input shaft of the motor, and the outer flanges of the two are parallel. As the heart is inconsistent, it will cause the motor shaft to break or the reducer gear to wear. Fluorocarbon Aluminum Plastic Panel In addition to fluorocarbon aluminum plastic panel excellent impact resistance, especially in severe weather conditions and environment shows long-term anti-decolorization, anti-ultraviolet light performance. U.S. research institutes have compared fluorocarbon coatings with super coatings and general coatings. Samples of the coatings have been exposed to scorching sun in Florida, United States, and 12 years of exposure to humid, salt-containing air. The stability and durability of fluorocarbon coatings and 80 points higher than those of the other two coatings. 3Mm Acm Panel,Acp Panel Cost,Alstone Aluminium Composite Panel,Fluorocarbon Aluminum Plastic Panel Shenyang Xiandai Jixiang Decorative Material Co., Ltd , https://www.modernbond-acp.com